ECU Protocol Data Converter (FEPC V1.7)
A Data Protocol-Converter compatible to Robbe/Futaba Sbus2 and JetCat Engine-Control-Unit (ECU) from Version 5.x, 6.x, 10.x. and 12.x
Firmware Version 1.7
Use and Features:
- Easy implementing, no PC is necessary! Plug and Play!
- Compatible to ECU´s from JetCat with Version 6.x and 10.x (plus ECU 6.x.R support**)
- Following ECU measuring values are transmitted to the radio control:
- ECU accumulation-voltage (Volt) with adjustable low voltage warning*
- Kerosine Pump Voltage* or display of FEPC Software Version**
- EGT exhaust temperature (°C)*
- Turbine driving-speed (U/min.)*
- Tank fuel volume with adjustable fuel alarm (buffer)*
- Fuel flow-rate*
- Turbine ECU Status (numerical)
- Turbine ECU last switch off condition (numerical)
- *Note: Upper and lower Alarm values can be set in the Transmitter
- ** New in Version 1.7
- The most important GSU data are visible in your Futaba radio control
- Galvanic separation of ECU- to receiver current circuit (it avoids electric blockages caused by the turbine or the turbine current circuit)! Maximum security for the Sbus2 user!
- Future-proof!!! A supplementary software upgrade is possible (new features)
- 40Mhz RISC CPU (fast processing of the measure values) Nano Watt Technology
- Small, light, also fits in smaller models
- English Manual
- Made in Germany
FEPC Protocol Converter Spezifications
Input voltage range: 4,5-9,0Volt
Measure values: ECU-Voltage, EGT, RPM, Tank- Volume, Pump-Voltage and Flowrate
Status values numerical: ECU-Status and OFF Condition
Save of Slot Adresses: Yes always in EEPROM
Galvanic seperation ECU/ RC: Yes fully isolated
Startup-Time: 2sec.
Optical signalisation: Bus Transmit
Sbus2 compatible: Yes full compatible
Measurements: W x L x D in mm 46 x 60 x 10
Weight: 35gr.
Scope of delivery: FEPC Protocol Converter with connection cable to ECU (RJ-11), Manual and Set-Card for ECU Status and Off-Condition.