Turbine Data Protocol Converter Pro-EMPC
The Pro-EMPC is a ECU data converter compatible with all ProJet Hornet-3 ECU´s (Tubine example list below).
It will sent the shown ECU meas values back to your Multiplex MSB telemetry.
Firmware Version 1.0
Benefit and features:
Easy implementation, no PC is necessary! Plug and Play! Compatible to ProJet Hornet-3 ECU´s.
Tailor made support of the following turbines.
BF Turbinen: BF100 und BF300
Hammer Turbinen: IQ90+, IQ130+, IQ140+, IQ170+, IQ180+, IQ190SS, IQ200+ u. IQ220+
Frank Turbine: FT160, FT180Raptor, FT220 und FT250 we are supporting Frank Turbines with brushless pumps too
Behotec: JB130, JB165, JB180 und JB220
The following ECU measured values are transmitted to the receiver:
- RPM of the turbine (RPM)
- EGT temperatur (°C/)
- Pump voltage with „Armed Alarm“ (fast Flame-Out warning)
- Pump maximum voltage reached during run
- Tank volume (mL) alarm will be set in the Futaba transmitter (TX)
- Kerosine / FuelFlow (mL/min.)
- Stick position in %
- ECU turbine battery voltage
- Turbinen status (only MPX PTX transmitter or telemetry display)
- All the main important ECU values at a glance
There will be no change in setting up your ECU parameter. The opperator can run the known EDT GSU terminal and the I/O board in paralell with the Pro-EMPC. The Pro-EMPC is not doing a so called terminal emulation. Please take a look at the above installation picture.
Galvanic Separation of ECU electric circuit to receiver electric circuit
(This prevents electric faults caused by the turbine or turbine electric circuit)
Future-proof!! Software Upgrade is possible supplementary (New Features)
20Mhz RISC CPU (Fast processing of the measured values) Nano Watt Technology
Small, light, also fits in small airplanes
English Manual
Made in Germany
Pro-EMPC Protocol Converter specifications:
Input voltage range: 4,5-9,0Volt
Measure values: ECU-Voltage, EGT, RPM, Stick-Position, Tank- Volume, Pump-Voltage, Turbine-Status, Pump max. value and Flowrate
Status values numerical: ECU-Status
Galvanic seperation ECU/ RC: Yes fully isolated
Startup-Time: 10sec. together with Hornet-3 ECU
Optical signalisation: MPX MSB Bus Transmit
Sbus2 compatible: Yes full compatible
Measurements: W x L x D in mm 46 x 60 x 10
Weight: 45gr. all components
Scope of delivery: Complete Pro-EMPC Protocol Converter with connection cable to ECU (RJ-11), data splitter and manual.