ECU Protocol Data Converter JJXC-EX
A Data Protocol-Converter compatible to Jeti EX telemetry and JetCat Engine-Control-Unit (ECU) from Version 5.x, 6.x, 10.x., 12.x and Robbe Ropulsion V.10 10R112.
Firmware Version 1.1
Use and Features:
• Compatible to ECU´s of JetCat from Version 6.x, 10.x, 6.10R und Robbe Ropulsion V.10 10R112
• Easy implementing, no PC is necessary! Plug and Play!
• Following ECU measuring values are transmitted in Jeti EX format to the radio control:
1. ECU accumulation-voltage (Volt) EX Data Display
2. EGT exhaust-temperature(°C) EX Data Display
3. Turbine driving speed (U/min.) EX Data Display
4. Tank fuel-volume (mL) EX Data Display
5. Fuel flow-rate (mL) EX Data Display
6. Pump-voltage (Volt) EX Data Display
7. ECU Turbine Status Jeti Box Display
8. ECU Off Status Jeti Box Display
9. Post Flight Min/Max pump-voltage Jeti Box Display
• The most important GSU data are visible in your radio control
• Galvanic separation of ECU- to receiver current circuit
• Future-proof!!! A supplementary software upgrade is possible (new features)
• 20Mhz RISC CPU (fast processing of the measure values) Nano Watt Technology
• Small, light, also fits in smaller models
• English Manual
• Made in Germany
JJXC-EX Protocol Converter Specifications
Input voltage of ECU / of receiver: 5,0Volt / up to max. 9Volt
Measure values for Jeti EX: ECU-Voltage, EGT, RPM, Tankvolume, Flow-Rate and Pump-voltage
Alarmvalues: Yes below EX Alarms
Save of Setup and Alarm: Inside the Radio-Control
Galvanic Separation ECU/ RC: Yes fully isolated
Startup-Time: 3sec.
Optical Signalisation: Bus Transmit
Jeti compatible: Yes Jeti EX
Measurements: W x L x D in mm 46 x 60 x 10
Weight: 35gr.