ECU Protokoll Daten Converter FEPC V2.0 Premium
A ECU data converter only compatible with Futaba Transmitter supporting the "JetCat Display" like T18MZ and the JetCat Engine-Control-Unit (ECU) Version 5.x, 6.x, 10.x. and 12.x.
Firmware Version 2.0
Benefits and Features:
Easy to install an opperate! Plug and Play!
Compatible with all ECU´s from JetCat since Version 6.x and 10.x (plus ECU 6.x.R)
The following measurement values will be transfered to the Futaba transmitter:
ECU Voltage with alarm value adjustable*
Kerosine Pump Voltage
Turbine EGT (°C)*
Turbine (RPM)*
Tank-Volume with alarm value adjustable (RESERVE FUEL)*
Fuel-Flow-Rate*
Turbine ECU Status
Turbine Power Force (N)
*Note: Upper and lower limit can be set inside the Futaba TX
The most important GSU data are visible in your Futaba radio control
Galvanic separation of ECU- to receiver current circuit (it avoids electric blockages caused by the turbine or the turbine current circuit)! Maximum security for the Sbus2 user!
Future-proof!!! A supplementary software upgrade is possible (new features)
40Mhz RISC CPU (fast processing of the measure values) Nano Watt Technology
Small, light, also fits in smaller models
English Manual
Made in Germany
FEPC Protocol Converter Spezifications
Input voltage range: 4,5-9,0Volt
Measure values: ECU-Voltage, EGT, RPM, Tank- Volume, Pump-Voltage, Power Force and Flowrate
Status values numerical: ECU-Status
Galvanic seperation ECU/ RC: Yes fully isolated
Startup-Time: 4sec.
Optical signalisation: Bus Transmit
Sbus2 compatible: Yes full compatible
Measurements: W x L x D in mm 46 x 60 x 10
Weight: 35gr.
Scope of delivery: FEPC Protocol Converter with connection cable to ECU (RJ-11) and Manual.