NH-5 Serial Bus Expander Power Hub
The NH-5 Serial Bus Expander is compatible to Robbe/ Futaba Sbus2 and Sbus serial Servo- data connection. The NH-5 decodes the serial Sbus/Sbus2 signals and provides those as regular PWM signal for until further 5 servos. Simultaneously the NH-5 serves a high-voltage, high-current Power Hub (Power distributor).
Firmware Version 1.0
- Use and Features:
- Easy implementing, Plug and Play!
- Compatible to all Robbe Futaba Sbus and Sbus2 Receiver
- Future-proof!!! An additional Software Upgrade is possible afterwards (New Features)
- 16BIT, 80Mhz RISC CPU (fast converting of Servo data) NanoWatt-Technology
- Super „Low-Latency“, Real-time-output of the servo-values
- 15ms Framerate (Servo Update Rate)
- 11Bit Servo-resolution (Futaba Specification)
- IPB Impulse Booster, integrated Servo impulse-amplifier for all 5 outputs
- Servos are supplied with high current (High Power / High Current Hub)
- Enhancement for receiver R7003SB, R7008SB for 5 additional PWM Servo-channels
- Sbus, Sbus2 Loop Port
- Small, light, also fits in smaller models
- German and English Manual
- Made in Germany
NH-5 Serial Expander / Power Hub
Input voltage: 4.2 - 9,0Volt
Resolution: 11Bit / 2048 Steps
Permitted Servo current per servo output: Max. 3A
Save of Setup Templates/Servo Out: Yes intern EE-Prom
Framerate: 15ms
Startup-time: 1sec.
Optical signalization: Bus Transmission Yes
Sbus und Sbus2 compatible: Yes fully compatible
Measurements: W x L x D in mm over all 37 x 54 x 11
Weight: 15gr.