P2B ProJet + IAS - CB Elektronics

Go to content

Turbine data protocol converter Pro-P2B + IAS Speed Sensor

The Pro-P2B + IAS data converter/sensor compatible with the CORE Telemetry from PowerBox Systems
Tailor made support for turbines using ProJet Hornet-3 ECU

Firmware Version 1.0

"Best in Class Turbine Dataconverter/Sensor"


Use and Features:

Easy implementing, no PC is necessary! Plug and Play! Compatible with ProJet Hornet-3 ECU and the fast CORE telemetry bus


„Customized” tailor made individual support (thrust indication and flow rate/min.) for the following turbines
BF Turbines: BF100 and BF300
Hammer Turbines: IQ90+, IQ130+, IQ140+, IQ170+, IQ180+, IQ190SS, IQ200+ u. IQ220+
Frank Turbine: FT160, FT180Raptor, FT220 and FT250 we are supporting Frank Turbines with brushless pumps too
Behotec: JB130, JB165, and JB220

The following ECU measured values are transmitted to the CORE radio control:
1. Turbine rotational speed (RPM)
2. EGT exhaust temperature (°C)
3. Pump voltage with „Armed Alarm“ (fast Flame-Out Warning)
4. Thrust in Newton (N), matched to the type of turbine (see above)
5. Tank content fuel amount (mL) alarm can be set within the CORE RC TX
6. Kerosene / fuel flow rate (mL/min.), matched to the type of turbine (see above)
7. Control stick gas default in %
8. ECU turbine accumulator operating voltage (ECU battery voltage)
9. Turbine status text indication, customized for Projet ECU Hornet-3
10. True IAS speed with our thousend times proven CB-IAS+ sensor technology

Imperial units like °F, lbf, fl.oz., oz/min. and mph are selectable.

The most important EDT data are directly visible in your CORE radio control.
No adjustment for the operation of the ECU parameters. The operator can further use the EDT GSU terminal and the I/O board. No terminal emulation occurs, therefore no reconnecting between data converter and EDT is necessary. Plug and Play with the CORE system

Support of up to 4 Turbines in one CORE telemetry installation (Turbine #1-4)

Future-proof!!! A supplementary software upgrade is possible (new features)
40Mhz RISC CPU (fast processing of the measure values) Nano Watt Technology
Full galvanic separation of radio control to ECU electric circuit
Small, light, also fits also in smaller models
Detailed english manual
Made in Germany


Scope of delivery: Pro-P2B Protocol Converter with special connection cable to the ECU. ECU I/O Splitter with cable for parallel operation of EDT GSU (Ground Support Unit) and Pro-P2B. CB IAS Plus sensor for true IAS speed display and indication (complete pitot tube and tubbing kit).

For quote please be so kind and use our contact form.

Copyright CB-Elektronics 2022
Back to content